Track Pin Tool and Sleeper Drilling Guide - TT:120

This is a TT:120 scale pin holder for laying track with a built in magnet to in control of escaping nails.

The design is to help make laying track easier we all know it can be a pain.

The pin holder has a drill locator that aligns your drill bit with the centre of a sleeper, to get a perfect hole location every time if you are needing to add extra pin holes in your sleepers.

Once drilled, simply place the nail against the magnet and being pinning.

The drill locating hole will accept drill bits up to 1.0mm diameter.

It is suggested to use a drill bit of approx 0.1mm less in diameter than the diameter of your track pins.

For example: if your track pins are 0.9mm diameter then use a 0.8mm diameter drill bit.

Track Pins are NOT included.

It is suggested to hold your drill bit in a suitable pin-vice as shown in the pictures (pin-vice is not included)

Months of design and development to ensure the best fine detail that can be achieved.

Printed in PLA.

Track and truck not included only for application purpose.